Re: [CAD_CAM_EDM_DRO] PCB Mill (Was Re: small stuff (list goals/aims/results?))
Posted by
Alan Marconett KM6VV
on 2001-05-11 11:49:22 UTC
Hi Kerry,
Thanks for posting the PIC files! What are you using to lay out the
circuit, and generate the Gcode? Or what program are you using to do
the "outline" of the traces?
Alan KM6VV
Kerry wrote:
Thanks for posting the PIC files! What are you using to lay out the
circuit, and generate the Gcode? Or what program are you using to do
the "outline" of the traces?
Alan KM6VV
Kerry wrote:
>
> > 1) What is this 'dermal' you mention?
> should be dremel
> http://www.dremel.com/Europe.html
>
> > 2) How good is the repeatability of your machine? (One of the
> reasons
> ive put a scan of the circuit in the files pic section BIPPOLER.jpg
> this is one of the first using one of the Dremel engraving bits i
> have since made a bit which dose a beter job but all the boards or in
> use and boxed up I will scan a new one the next time i do one. Proper
> mechanical eching bits would be better ive got some on order I will
> let you know how i get on.
> > I've not gotten very far on the machine is that I worry that the
> > resulting machine might not be accurate enough for making simple
> > printed circuit boards.
> >
> > Thanks!
> >
> > --marco
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Discussion Thread
Alan Marconett KM6VV
2001-05-11 11:49:22 UTC
Re: [CAD_CAM_EDM_DRO] PCB Mill (Was Re: small stuff (list goals/aims/results?))
Kerry
2001-05-11 15:50:11 UTC
PCB Mill (Was Re: small stuff (list goals/aims/results?))
Alan Marconett KM6VV
2001-05-11 18:22:26 UTC
PCB Mill (Was Re: small stuff (list goals/aims/results?))