Re: [CAD_CAM_EDM_DRO] RF45 CNC conversion
Posted by
Alan Marconett KM6VV
on 2001-05-17 15:05:24 UTC
Hi Dan,
Thanks for the comments. I don't think I'm up to that! And I chickened
out on a BOSS 5 mill, too big, too soon!
Alan KM6VV
dfalck@... wrote:
Thanks for the comments. I don't think I'm up to that! And I chickened
out on a BOSS 5 mill, too big, too soon!
Alan KM6VV
dfalck@... wrote:
>
> Alan,
> I cut a hole in the top of the column. It was 3/4" thick cast iron, so I had to do it slow and with a lot of cutting oil to keep the hole saw cool. I used a big Milwaulkee mag drill set on a make shift platform that I leveled up to the top of the column. The platform was a right angle plate clamped to the side of it. If I had had more room in my shop at the time, I probably would have bought a Boss mill- and not gone to the trouble that I did. But, with little space at that time and less now it makes sense to have a RF45 conversion.
>
> Dan
>
> >What did you cut a hole in the top of? the stand? The plate goes
> >between the base and the square column? Well, I'm a long way off >from doing my own RF conversion (I HAVE a Sherline CNC), but I might >be looking at a mill this weekend!
>
> >Alan KM6VV
Discussion Thread
dfalck@s...
2001-05-17 05:26:37 UTC
RF45 CNC conversion
Alan Marconett KM6VV
2001-05-17 15:05:24 UTC
Re: [CAD_CAM_EDM_DRO] RF45 CNC conversion