Re: Re: Newbie: milling control

In a message dated 09/16/1999 9:41:24 AM Hawaiian Standard Time,
drewid@... writes:

<< It has lots of wires going from its old controller, but I'm not sure
which controls the motors, which is encoder,
limit-switch, or tachometer feedback, which controls the oiler (defunct)
and what to cut. >>
Andrew,
I will take care of it. Just send it to me. If that's not feasible, take a
picture so list members can help give pointers/advise on what to do and not
to do.
Peter
PT Engineering Co.
Honolulu Hawaii