CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Eliminating part of Subject Line?

on 2001-06-10 07:25:24 UTC
On Sun, 10 Jun 2001 09:08:38 -0500, "Bill McGown"
<bmcgown@...> wrote:

>Is there any way to eliminate the [CAD_CAM_EDM_DRO] part in the message
>subject line in Outlook Express? (see below)
>
>Subject: RE: [CAD_CAM_EDM_DRO] Propeller blades, was: 4-AXIS FOAM CUTTER
>
>Since I direct all messages to a CAD CAM folder that part is redundant
>and makes reading and sorting the subject line a bit difficult. Many
>thanks in advance.

I wonder if some folks use it as a filter key?

Fitch
In So. Cal.

The FAQ for RCM is: http://w3.uwyo.edu/~metal
Metal Web News at http://www.metalwebnews.com
The "Drop Box" is at http://www.metalworking.com/

Discussion Thread

Bill McGown 2001-06-10 07:08:26 UTC Eliminating part of Subject Line? Fitch R. Williams 2001-06-10 07:25:24 UTC Re: [CAD_CAM_EDM_DRO] Eliminating part of Subject Line? Art Fenerty 2001-06-10 07:42:00 UTC Re: [CAD_CAM_EDM_DRO] Eliminating part of Subject Line? Bill McGown 2001-06-10 07:52:11 UTC Re: [CAD_CAM_EDM_DRO] Eliminating part of Subject Line? A. G. Eckstein 2001-06-10 07:55:13 UTC Re: [CAD_CAM_EDM_DRO] Eliminating part of Subject Line? Fitch R. Williams 2001-06-10 08:03:29 UTC Re: [CAD_CAM_EDM_DRO] Eliminating part of Subject Line? Paul 2001-06-10 08:04:00 UTC Re: [CAD_CAM_EDM_DRO] Eliminating part of Subject Line? Tim Goldstein 2001-06-10 10:29:46 UTC RE: [CAD_CAM_EDM_DRO] Eliminating part of Subject Line? Ian Wright 2001-06-11 00:05:15 UTC Re: [CAD_CAM_EDM_DRO] Eliminating part of Subject Line?