Re: [CAD_CAM_EDM_DRO] Eliminating part of Subject Line?

Just as one responder, YES, that is how I filter my message; however, there
are other ways it can be done.

At 10:20 AM 6/10/01, you wrote:

>On Sun, 10 Jun 2001 09:08:38 -0500, "Bill McGown"
><bmcgown@...> wrote:
>
> >Is there any way to eliminate the [CAD_CAM_EDM_DRO] part in the message
> >subject line in Outlook Express? (see below)
> >
> >Subject: RE: [CAD_CAM_EDM_DRO] Propeller blades, was: 4-AXIS FOAM CUTTER
> >
> >Since I direct all messages to a CAD CAM folder that part is redundant
> >and makes reading and sorting the subject line a bit difficult. Many
> >thanks in advance.
>
>I wonder if some folks use it as a filter key?
>
>Fitch
>In So. Cal.
>

Bubba

OLDER THAN DIRT
Country Bubba
(Actually the inventor of Country and Bubba)

axtein@...
LaGrange, GA

http://www.surfsouth.com/~axtein


[Non-text portions of this message have been removed]