CAD CAM EDM DRO - Yahoo Group Archive

Re: True 4th Axis milling

Posted by machines@n...
on 2001-06-10 11:55:36 UTC
--- In CAD_CAM_EDM_DRO@y..., Brian Pitt <bfp@e...> wrote:
>

>
> about the #2 method in Vector
> could that cut say a 'J' shaped cam grove onto a cylinder using
> a cutter with a diameter smaller than the grove width and still
keep the
> sidewalls of the grove parallel?
>
Brian, Look at:-
http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/rotary%20cam1.jpg

Is this what you mean ?
The groove is 5.2mm but is cut in two passes with a 5.0 cutter. Each
cut is 0.1mm offset from the centreline.

John Stevenson

Discussion Thread

William Reidsema 2001-06-10 03:36:11 UTC True 4th Axis milling Fred Smith 2001-06-10 10:41:45 UTC Re: True 4th Axis milling Brian Pitt 2001-06-10 11:36:19 UTC Re: [CAD_CAM_EDM_DRO] Re: True 4th Axis milling machines@n... 2001-06-10 11:55:36 UTC Re: True 4th Axis milling Brian Pitt 2001-06-10 12:32:39 UTC Re: [CAD_CAM_EDM_DRO] Re: True 4th Axis milling Chris Stratton 2001-06-10 12:45:41 UTC Re: [CAD_CAM_EDM_DRO] Re: True 4th Axis milling Brian Pitt 2001-06-10 13:26:23 UTC Re: [CAD_CAM_EDM_DRO] Re: True 4th Axis milling IMService 2001-06-10 13:28:40 UTC Re: Re: True 4th Axis milling Brian Pitt 2001-06-10 15:20:43 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: True 4th Axis milling machines@n... 2001-06-10 15:24:36 UTC Re: True 4th Axis milling Jon Elson 2001-06-10 20:31:25 UTC Re: [CAD_CAM_EDM_DRO] Re: True 4th Axis milling Brian Pitt 2001-06-10 23:29:51 UTC Re: [CAD_CAM_EDM_DRO] Re: True 4th Axis milling