of what use is the old controller for a Bridgeport CNC mill?
Posted by
Elliot Burke
on 1999-09-17 08:00:21 UTC
I have a mid 80's vintage Bridgeport CNC mill and am converting to to Dan
Mauch's drivers.
There are two large boxes of electronics on this thing, including power
supplies, tapes drives, computer?, and so on. Is this stuff of any use? Is
there someone that buys this stuff, or should it just go to the dump? Seems
a shame. I may recyle the connectors.
On a similar note, does anyone know where I can get a manual for this thing?
Elliot Burke
Mauch's drivers.
There are two large boxes of electronics on this thing, including power
supplies, tapes drives, computer?, and so on. Is this stuff of any use? Is
there someone that buys this stuff, or should it just go to the dump? Seems
a shame. I may recyle the connectors.
On a similar note, does anyone know where I can get a manual for this thing?
Elliot Burke
Discussion Thread
Elliot Burke
1999-09-17 08:00:21 UTC
of what use is the old controller for a Bridgeport CNC mill?
Matt Shaver
1999-09-17 08:40:14 UTC
Re: of what use is the old controller for a Bridgeport CNC mill?