mid-range instability was Re: Allegro 2961 uptdate
Posted by
lonnietoons@y...
on 2001-07-08 08:13:40 UTC
--- In CAD_CAM_EDM_DRO@y..., ballendo@y... wrote:
Can you give me some web sites where I can take a look at Lanchester
dampeners? I did some searches but did not find any.
Lonnie
> Hello,of
>
> First, I'll assume you are not trying to make decisions based on
> unloaded motors...
>
> Lanchester dampeners are the "classic" solution. These consist of a
> viscous fluid contained in a housing around a metal disk which is
> driven by the motor (often the 2nd shaft is used). The additional
> damping provided by this "raw egg" spinning reduces/eliminates the
> resonance.
>
> Good machine design will also help. Very often motors are sized
> incorrectly for the load and speed needs of the system. I'm guilty
> trying "what I have" instead of always calc'inc the correct motorfor
> the intended use. ALL the major motor mfrs. have motor "sizing"will
> software freely available. If you are not using their motors you
> need to cross reference to what you intend to use...to
>
> Thirdly, and related to the above; the simple addition of friction
> the machine drive assembly may help.machine
>
> The BEST way to deal with mid-range resonance is to use good
> design, AND use a drive (like the Geckos' ) which have beendesigned
> with the reduction of this problem in mind...Thanks Ballendo.
>
> Hope this helps.
>
> Ballendo
>
Can you give me some web sites where I can take a look at Lanchester
dampeners? I did some searches but did not find any.
Lonnie
Discussion Thread
lonnietoons@y...
2001-06-26 21:03:32 UTC
Allegro 2961 uptdate
Jon Elson
2001-06-26 23:40:02 UTC
Re: [CAD_CAM_EDM_DRO] Allegro 2961 uptdate
lonnietoons@y...
2001-06-28 07:51:10 UTC
Re: Allegro 2961 uptdate
Scott M. Thomas
2001-07-05 09:15:25 UTC
RE: [CAD_CAM_EDM_DRO] Allegro 2961 uptdate
lonnietoons@y...
2001-07-06 06:11:13 UTC
Re: Allegro 2961 uptdate
Jon Elson
2001-07-06 10:35:11 UTC
Re: [CAD_CAM_EDM_DRO] Re: Allegro 2961 uptdate
lonnietoons@y...
2001-07-06 17:32:21 UTC
Re: Allegro 2961 uptdate
ballendo@y...
2001-07-06 21:08:55 UTC
mid-range instability was Re: Allegro 2961 uptdate
lonnietoons@y...
2001-07-08 08:13:40 UTC
mid-range instability was Re: Allegro 2961 uptdate