Re: [CAD_CAM_EDM_DRO] Re: Scraping

----- Original Message -----
From: Chris Stratton <stratton@...>

> Since scraping has come up, I'm wondering if anyone could comment on how
one scrapes the inside-slanted surface of dovetails?

Scraping dovetails often requires considerable practice. The scraper is
usually smaller for getting into the corner. You also need a bevelled
straightedge to do your markings properly. I did a B&S mill without one and
would not recommend it. The casting offered by Mike Morgan has a bevelled
edge for this purpose.

If I were building a slide from scratch I would probably use square or V
ways as they are easier to construct. You can also avoid scraping one
surface if you use Moglice to cast it in place.

Doug