Re: [CAD_CAM_EDM_DRO] Digital caliper interface.

Hi Jens,

there is a german page with exactly the interface you are looking for.
perhaps you get more information from rainer radow.

good luck

Martin Kelbel
always reply to: bitte immer an folgende Adresse antworten:
e-mail: martin.kelbel@...
Unterer Markt 2
90518 Altdorf
Germany

----- Original Message -----
From: "J. J. Larsen" <jjl@...>
To: "cad_cam" <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Sunday, July 29, 2001 11:36 AM
Subject: [CAD_CAM_EDM_DRO] Digital caliper interface.


> Hi all.
>
> I have bought 2 cheap Taiwan/China made digital calipers. It´s my
intension
> to mount them on my mill, so they can work as a DRO.
>
> On the calipers, under a small cap, there is a 4 pole PCB edge-connector
> interface. What is that for ? Is it some kind of output ( rs232,
> quadratur ) to an external display ? or is it some kind of factory
> calibration interface ?
> The "manual" ( a little piece of paper) tells nothing.
>
> If it´s some kind of output (what I hope it is) I will try to make some
kind
> of external display.
>
>
> Does anyone have any information, links, plans for interfacing, software ?
>
>
> Thanks in advance
>
> Jens J. Larsen
> Denmark
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>