CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Fanuk backlash compensation

on 2001-08-01 05:38:35 UTC
Dear friends,
you didn't hear from me the last weeks because I scraped
the table of a 7 ton Hillier bedmill. My hole body still aches.
Now that I have aligned the head and tightened the ballnut mounts
I want to compensate the backlash of the directions but the control
doesn't let me into the parameter settings.
It is a Fanuk 11 series control. and the backlash compensation
parameters
are in number 1851.
First you shall put in parameter 8000 a 1 into the PWE bit (last one),
what I finally where able to do. But still the control tells me that the
parameter is write protected.

Who can help me on?


By the way this is the machine I mentioned a month ago that it once was
under
military secret. And when it had to be reinitialized several years ago
because
the system fell out trying to get into the parameter settings.
The owner had to get a special permit from Pentagon before Fanuk sold
him
the hardware key for this task.
Any answer is very much welcome.

Thanks a lot
Sven Peter


[Non-text portions of this message have been removed]

Discussion Thread

Sven Peter, TAD S.A. 2001-08-01 05:38:35 UTC Re: [CAD_CAM_EDM_DRO] Fanuk backlash compensation diazden 2001-08-01 08:54:48 UTC Re: [CAD_CAM_EDM_DRO] Fanuk backlash compensation