Re: [CAD_CAM_EDM_DRO] Cutting stainless steel sheets
Posted by
Jon Elson
on 2001-08-01 20:11:20 UTC
Randy Poon wrote:
bent, however. If the sheet is fairly thick (1/16" or more)
then you can probably use a bandsaw with a fine toothed
blade. I imagine there may be some blade setup for a
table saw that might be able to do it, too. You'd probably
want to clamp the sheet between two pieces of plywood
to support it.
Jon
> Sorry, it sounds like a stupid question, but I'm NOT aThe simplest thing is tin snips. This will leave one edge
> machinist. I need to cut a stainless steel sheet into
> tiny squares of size 3" x 3", what is the proper tool
> to use? I prefer cheaper solution since I don't have
> expensive machine with me.
bent, however. If the sheet is fairly thick (1/16" or more)
then you can probably use a bandsaw with a fine toothed
blade. I imagine there may be some blade setup for a
table saw that might be able to do it, too. You'd probably
want to clamp the sheet between two pieces of plywood
to support it.
Jon
Discussion Thread
Randy Poon
2001-08-01 10:11:59 UTC
[CAD_CAM_EDM_DRO] Cutting stainless steel sheets
David M. Munro
2001-08-01 11:29:19 UTC
Re: [CAD_CAM_EDM_DRO] Cutting stainless steel sheets
JanRwl@A...
2001-08-01 13:02:09 UTC
Re: [CAD_CAM_EDM_DRO] Cutting stainless steel sheets
JanRwl@A...
2001-08-01 13:06:33 UTC
Re: [CAD_CAM_EDM_DRO] Cutting stainless steel sheets
Smoke
2001-08-01 13:57:56 UTC
Re: [CAD_CAM_EDM_DRO] Cutting stainless steel sheets
info.host@b...
2001-08-01 15:59:01 UTC
Re: [CAD_CAM_EDM_DRO] Cutting stainless steel sheets
Jerry Kimberlin
2001-08-01 19:03:39 UTC
Re: [CAD_CAM_EDM_DRO] Cutting stainless steel sheets
Jon Elson
2001-08-01 20:11:20 UTC
Re: [CAD_CAM_EDM_DRO] Cutting stainless steel sheets