Emc Help! Help! Help!

Firstly Thanks to everyone who has help thus far.....

When I enter a high number for INPUT_SCALE say 10000 the machine locks.
It seems to work better with a low number say 800!
But I need 4 turns of motor to 1mm which = a value of 1016 for
INPUT_SCALE ( I think)


So I tried the freqmod this is running on a pentium pro 200 which has a
advanced method for calculations I am led to believe.

The problem now is that the position number in the gui fluctuates up and

down and the motor either caries on spinning or sometimes makes strange
noises.

Could you give me any pointers with regards to freqmod and also could
you let me know of a fixed steppermod.o I am currently using the one
which I installed from BDI which I downloaded two nights ago not sure
what version.

Oh I also enabled PERIOD (emc.ini) to see if this would sort the freqmod
problem.
It did not but it did hang my machine if the number was to small ie
.000016 etc...

Thanks in Advance

Steve G..