Re: [CAD_CAM_EDM_DRO] Chinese DRO/Caliper 4 pin interface

Hi Roger
make a search in the files section ,earlier in the year the
files that you are looking for were loaded with the data
on those calipers
regards
mariano

----- Original Message -----
From: <vrsculptor@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, August 14, 2001 12:00 AM
Subject: [CAD_CAM_EDM_DRO] Chinese DRO/Caliper 4 pin interface


> The cheap Chinese caliper and DRO's have a 4 wire interface. Has
> anyone interfaced to one of these? Any info would be appreciated. I'm
> thinking of using one for probing... Use the mill to step to a
> position, gravity drop probe attached to DRO, read serial data, pick
> up probe, next. I'd like to avoid using Z-axis as a simple pick up
> and drop would be much faster than feeding.
>
> I know, I can figure it out with the scope but it would be so much
> easier if someone already knows.
>
> Roger
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>