Re: [CAD_CAM_EDM_DRO] Re: Chinese DRO/Caliper 4 pin interface

Hi Roger;
I was the one that send the file to one of the members
on this list and he told me that he put them in the files
section , I don't know were I put the data sheets but I will
look in my emails and try to send them to you, for what I
can remember it is a pseudo serial data 24 bits or something like that
regards
Mariano

----- Original Message -----
From: <vrsculptor@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, August 14, 2001 6:03 AM
Subject: [CAD_CAM_EDM_DRO] Re: Chinese DRO/Caliper 4 pin interface


> --- In CAD_CAM_EDM_DRO@y..., "diazden" <diazden@b...> wrote:
> > Hi Roger
> > make a search in the files section ,earlier in the year the
> > files that you are looking for were loaded with the data
> > on those calipers
> > regards
> > mariano
> >
> Mariano,
> I looked at the dropbox... it was for an 8 pin Japanese caliper.
> Definately a couple of cuts above the Chinese. I was hoping for
> something more applicable. I may just end up hacking it.
>
> Roger
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>