Re: [CAD_CAM_EDM_DRO] router designs

Hi, Jan

> OK, if we are posting photos of stuff we have done; HERE is one I built

for

> drilling PCB holes in '84. There is a 12,000 RPM, 400-Hz. 3-phase

"aircraft

> instrument motor" in the quill, with a 1/8" collet affixed thereto (whew!

Lot

> of "fine" work, that!). the Slo-Syn atop the quill is down-feed. Z is

about

> 0.2".

Very nice and clean design. I really like it...

Do you have any more pictures from the other side of the table ?? How
did you drive the X axys ? I could not figure out by the picture. Do you
drive just at one side ? Doesn't the table stop at the other side ?

Best regards,
Alexandre Guimaraes