Re: [CAD_CAM_EDM_DRO] maxnc gcode
Posted by
Marcus & Eva
on 2001-08-16 19:12:27 UTC
Hi Ed:
If you're using Featurecam, you should have a whole boatload of post
processors with it.
Fanuc is a real common one, Haas is virtually the same.
Another thing about Featurecam that you may not be aware of, is that the
post processor editor is the best in the business by far.
It is really easy to customize a post processor from Featurecam.
Not at all like the incomprehensible gobbledegook you have to struggle with
in Mastercam.
Give it a try; I'm sure you will find it pretty simple.
Cheers
Marcus
-----Original Message-----
From: blueveil@... <blueveil@...>
To: CAD_CAM_EDM_DRO@yahoogroups.com <CAD_CAM_EDM_DRO@yahoogroups.com>
Date: Thursday, August 16, 2001 1:55 PM
Subject: [CAD_CAM_EDM_DRO] maxnc gcode
If you're using Featurecam, you should have a whole boatload of post
processors with it.
Fanuc is a real common one, Haas is virtually the same.
Another thing about Featurecam that you may not be aware of, is that the
post processor editor is the best in the business by far.
It is really easy to customize a post processor from Featurecam.
Not at all like the incomprehensible gobbledegook you have to struggle with
in Mastercam.
Give it a try; I'm sure you will find it pretty simple.
Cheers
Marcus
-----Original Message-----
From: blueveil@... <blueveil@...>
To: CAD_CAM_EDM_DRO@yahoogroups.com <CAD_CAM_EDM_DRO@yahoogroups.com>
Date: Thursday, August 16, 2001 1:55 PM
Subject: [CAD_CAM_EDM_DRO] maxnc gcode
>Has anyone found a good flavor of gcode for the maxnc. I have
>used fanuc15 in the past with good results, but the new software
>I am using doesn't have that output. Anything better than generic
>g-code would be greatly appreciated.
>
>Ed.
>
>P.S. I am using featurecam, but any windows cam software that
>outputs g-code should get me in the ballpark
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
Discussion Thread
blueveil@e...
2001-08-16 13:55:52 UTC
maxnc gcode
Marcus & Eva
2001-08-16 19:12:27 UTC
Re: [CAD_CAM_EDM_DRO] maxnc gcode