CAD CAM EDM DRO - Yahoo Group Archive

Re: Homemade Ballscrew conversion for Shoptask finished.....

Posted by John
on 2001-08-22 17:47:19 UTC
Well when you buy a ball nut they come with a insert use it NEVER
remove a ball nut with out it or You will lose the balls just hold
the insert up to the end of the lead screw and thread the nut on or
off tthe screw to keep the ball in the nut .


John

--- In CAD_CAM_EDM_DRO@y..., wanliker@a... wrote:
> In a message dated 8/22/2001 9:39:39 AM Pacific Daylight Time,
> mmueller@n... writes:
>
>
> >
> > The hardest part of this conversion was putting the balls back in
the
> > leadnuts, anyone have a sure fire way to get all of them in there?
> >
>
> slowly...
> bill
>
>
> [Non-text portions of this message have been removed]

Discussion Thread

mmueller@n... 2001-08-22 09:37:57 UTC Homemade Ballscrew conversion for Shoptask finished..... Doug Harrison 2001-08-22 14:50:50 UTC Re: [CAD_CAM_EDM_DRO] Homemade Ballscrew conversion for Shoptask finished..... wanliker@a... 2001-08-22 17:22:48 UTC Re: [CAD_CAM_EDM_DRO] Homemade Ballscrew conversion for Shoptask finished..... John 2001-08-22 17:47:19 UTC Re: Homemade Ballscrew conversion for Shoptask finished..... Jon Elson 2001-08-22 23:46:22 UTC Re: [CAD_CAM_EDM_DRO] Homemade Ballscrew conversion for Shoptask finished.....