Re: [CAD_CAM_EDM_DRO] Handling EMC source on Windoze

Winrar will decompress tar files.

later,
Larry E.

----- Original Message -----
From: "Paul" <Paul.Corner@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Sunday, August 26, 2001 9:37 AM
Subject: Re: [CAD_CAM_EDM_DRO] Handling EMC source on Windoze


>
> Hi Wally
>
> Short of downloading the sources direct from SourceForge, I'm not sure if
there
> are any Windows utilities to decompress tarballs.
>
> Regards, Paul.
>
>
> On Sun, 26 Aug 2001, Wally Daniels wrote:
> > Hello Folks,
> >
> > With recent talk on look ahead cutter-comp and such, I'm interested at
> > looking at the EMC ( again ).
> > However without Linux on my system, I was wondering what avenues are
> > availible to un-archive the source
> > on a windows system.
> >
> > Any help is appreciated, Wally
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>