RE: [CAD_CAM_EDM_DRO] CNC test...

Where might one get a copy of Fred's test program?

John Guenther

> -----Original Message-----
> From: dougrasmussen@... [mailto:dougrasmussen@...]
> Sent: Tuesday, August 28, 2001 12:46 PM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: [CAD_CAM_EDM_DRO] CNC test...
>
>
> Group,
>
> FWIW, I ran Fred's test program on my Dynapath Delta 20 controller
> with Intel 186 chip at F25.
>
> 201 seconds using buffered input. The program file is big enough it
> wouldn't fit into memory, with existing programs in memory I only had
> 20K available.
>
> The buffered input comes in through the rs232 connection, not sure if
> this slowed things down since there were no apparent pauses.
>
> BTW, on my first run the control coughed at line N100000. Too large
> a numerical value. I renumbered and ran again.
>
> thanks,
>
> Doug
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>