Re: Suggestions for cnc software, with cutter radius compensation?
Posted by
alenz@c...
on 2001-08-31 23:30:10 UTC
--- In CAD_CAM_EDM_DRO@y..., Alan Marconett KM6VV <KM6VV@a...> wrote:
files? I tried every combination of the DXF functions listed
on Page 350 of the manual but was never able to get the arcs to
come out right consistantly. Sometimes the X was reversed,
other times the Y was displaced.
Al
> Hi Tom,the
>
> Get the Vector CAD-only demo, you can generate tool paths with the
> appropriate tool offsets! The CAD/CAM version will then generate
> Gcode, or you can use the ACE converter program!Alan, are you able to get Ace to properly convert Vector DXF
files? I tried every combination of the DXF functions listed
on Page 350 of the manual but was never able to get the arcs to
come out right consistantly. Sometimes the X was reversed,
other times the Y was displaced.
Al
Discussion Thread
tom.kay@n...
2001-08-31 06:01:50 UTC
Suggestions for cnc software, with cutter radius compensation?
Alan Marconett KM6VV
2001-08-31 11:38:34 UTC
Re: [CAD_CAM_EDM_DRO] Suggestions for cnc software, with cutter radius compensation?
Fred Smith
2001-08-31 14:16:56 UTC
Re: Suggestions for cnc software, with cutter radius compensation?
Carol & Jerry Jankura
2001-08-31 19:04:36 UTC
RE: [CAD_CAM_EDM_DRO] Suggestions for cnc software, with cutter radius compensation?
alenz@c...
2001-08-31 23:30:10 UTC
Re: Suggestions for cnc software, with cutter radius compensation?
Alan Marconett KM6VV
2001-09-01 10:56:38 UTC
Re: Suggestions for cnc software, with cutter radius compensation?