Re: [CAD_CAM_EDM_DRO] Re: EMC source code problem/Exciting NEWS!

Great news, Jon.

Keep us posted.

Tom Eldredge

----- Original Message -----
From: Jon Elson <elson@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, September 04, 2001 12:14 AM
Subject: [CAD_CAM_EDM_DRO] Re: EMC source code problem/Exciting NEWS!


> Thanks to Art Fenerty for the comments - I pretty much figured out the
> same thing while mulling over the results of browsing code and trying
> to make things work.
>
> The exciting news is I have finally cracked the mystical techniques
> needed to make the digital I/O funnel through the real-time section
> of EMC, so that all I/O can go through one parallel port! So, I have
> now completed the last hurdle to getting Digital I/O integrated with the
> rest of the PPMC card set. Also, this was needed to complete the
> 4 axis stepper rate generator with encoder counters plus digital I/O
> all on one board project. I still have to lay out these boards and do
> some cleanup of the code and getting all the I/O responses to go
> to the right places, but the hard part (just getting the separate
> programs to communicate) is done!
>
> WOW! This was harder than I thought it would be, by a LARGE
> margin!
>
> Jon
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>