CNC, Fix it or replace it
Posted by
Bruce Klawiter
on 2001-09-06 05:19:18 UTC
Hello all,
I am in need of some guidance.
I have an 1989 Anilam M controller on a Lagun mill. I have been quoted $2000.00 to repair this, a CPU board and counter board are both bad. I have been thinking of running EMC and if I did that I would be using the Parallel Port Axis Control, from Jon Elson.
Should I fix it or switch to EMC? Any thoughts would be appreciated.
Bruce Klawiter
[Non-text portions of this message have been removed]
I am in need of some guidance.
I have an 1989 Anilam M controller on a Lagun mill. I have been quoted $2000.00 to repair this, a CPU board and counter board are both bad. I have been thinking of running EMC and if I did that I would be using the Parallel Port Axis Control, from Jon Elson.
Should I fix it or switch to EMC? Any thoughts would be appreciated.
Bruce Klawiter
[Non-text portions of this message have been removed]
Discussion Thread
Bruce Klawiter
2001-09-06 05:19:18 UTC
CNC, Fix it or replace it
dougrasmussen@c...
2001-09-06 08:40:27 UTC
Re: CNC, Fix it or replace it
Jon Elson
2001-09-06 11:06:04 UTC
Re: [CAD_CAM_EDM_DRO] CNC, Fix it or replace it
Ray
2001-09-07 07:17:23 UTC
Re: CNC, Fix it or replace it
tom@t...
2001-09-07 08:07:20 UTC
Re: CNC, Fix it or replace it
Carol & Jerry Jankura
2001-09-07 08:43:03 UTC
RE: [CAD_CAM_EDM_DRO] Re: CNC, Fix it or replace it
Paul
2001-09-07 12:20:49 UTC
Re: [CAD_CAM_EDM_DRO] Re: CNC, Fix it or replace it
Don Chandler
2001-09-07 19:07:33 UTC
CNC, Fix it or replace it