Where to get it fixed, previously CNC, Fix it or replace it two

Well it looks like Emc is the way I'm going to go but before I do that I think I'll make a last ditch effort to see if I can get it fix at a reasonable cost. Does anybody know where or can anybody fix this? two of the boards are bad one is the CPU board and I don't know what the other on does. I know there bad I just don't know what is wrong with them. Anybody have any ideas?
Your help will be greatly appreciated.

Bruce Klawiter two

Hello all,

>I am in need of some guidance.
>I have an 1989 Anilam M controller on a Lagun mill. I have been quoted
>$2000.00 to repair this, a CPU board and counter board are both bad. I
>have been thinking of running EMC and if I did that I would be using the
>Parallel Port Axis Control, from Jon Elson. Should I fix it or switch to
>EMC? Any thoughts would be appreciated.

[Non-text portions of this message have been removed]