EMC Real World Again
Posted by
Ethan Vos
on 2001-09-11 06:58:07 UTC
Well after much discussion with PacSci I know what's happening. The
Compumotor Zeta drivers in the machine I have is micro-stepping the motors
25:1 or 5,000 pulses to 200 pulses.
What will happen if I drop the ratio down to 5:1? How much rougher will the
motor run? Will it be noticeable?
If I go to servos, what are the best drivers? Will the STG board drive the
servos direct or do I also need an outside power supply?
Ethan
Compumotor Zeta drivers in the machine I have is micro-stepping the motors
25:1 or 5,000 pulses to 200 pulses.
What will happen if I drop the ratio down to 5:1? How much rougher will the
motor run? Will it be noticeable?
If I go to servos, what are the best drivers? Will the STG board drive the
servos direct or do I also need an outside power supply?
Ethan
Discussion Thread
Ethan Vos
2001-09-11 06:58:07 UTC
EMC Real World Again
Jon Elson
2001-09-11 15:48:00 UTC
Re: [CAD_CAM_EDM_DRO] EMC Real World Again