CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Double Stepping???

on 2001-09-15 12:41:02 UTC
Hey Jerry,

At 11:46 AM 9/15/01 -0400, you wrote:

>experience with this combination of driver software? If so, I'd appreciate
>any ideas of what is happening or where else to start looking.

Two words--absolute coordinates. You're moving each axis from +1 to -1, a
distance of two inches.

Best regards,

Randy

Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.rickadee.net/~zephyrus

Discussion Thread

Carol & Jerry Jankura 2001-09-15 11:06:23 UTC Double Stepping??? Randy Gordon-Gilmore 2001-09-15 12:41:02 UTC Re: [CAD_CAM_EDM_DRO] Double Stepping??? Randy Gordon-Gilmore 2001-09-15 12:44:18 UTC Re: [CAD_CAM_EDM_DRO] Double Stepping??? Henrik Olsson 2001-09-15 13:11:29 UTC Re: [CAD_CAM_EDM_DRO] Double Stepping??? William Scalione 2001-09-15 13:36:59 UTC Re: [CAD_CAM_EDM_DRO] Double Stepping??? Carol & Jerry Jankura 2001-09-15 19:10:48 UTC RE: [CAD_CAM_EDM_DRO] Double Stepping??? Carol & Jerry Jankura 2001-09-15 19:14:50 UTC RE: [CAD_CAM_EDM_DRO] Double Stepping??? Alan Marconett KM6VV 2001-09-16 20:48:32 UTC Re: [CAD_CAM_EDM_DRO] Double Stepping??? Carol & Jerry Jankura 2001-09-17 02:33:33 UTC RE: [CAD_CAM_EDM_DRO] Double Stepping??? Alan Marconett KM6VV 2001-09-17 15:19:35 UTC Double Stepping???