RE: [CAD_CAM_EDM_DRO] Double Stepping???

Randy:

This makes a lot of sense, and explains exactly what I've noticed. Assuming
that the program considered the position at "start-up" to be zero, then the
G00 X1 would move only one inch, while the G00 X-1 would cause a move of two
inches. Thanks a lot for the explanation.

-- Carol & Jerry Jankura
Strongsville, Ohio
So many toys, So little time....

| -----Original Message-----
| From: Randy Gordon-Gilmore [mailto:zephyrus@...]
| Sent: Saturday, September 15, 2001 2:09 PM
| To: cad_cam_edm_dro@yahoogroups.com
| Subject: Re: [CAD_CAM_EDM_DRO] Double Stepping???
|
|
| Hey Jerry,
|
| At 11:46 AM 9/15/01 -0400, you wrote:
|
| >experience with this combination of driver software? If so, I'd
| appreciate
| >any ideas of what is happening or where else to start looking.
|
| Two words--absolute coordinates. You're moving each axis from +1 to -1, a
| distance of two inches.