RE: [CAD_CAM_EDM_DRO] engraving software

Elliot,
Try this link:
http://www.deskam.com/deskengrave.html

Bryan

-----Original Message-----
From: Elliot Burke [mailto:elliot@...]
Sent: Sunday, 16 September, 2001 1:20 PM
To: CAD_CAM_EDM_DRO
Subject: [CAD_CAM_EDM_DRO] engraving software


A few months ago there was a freeware engraving program mentioned here.
Since then my hard drive crashed, taking with it a weeks work and that URL.
As I recall it was a windows program, did engraing in a line or on an arc.

Does anyone have any ideas where it is?

It would be really nice if an engraving program understood that an engraving
cutter is a cone. Do they?

Am being more careful about backups now, thanks.

Elliot Burke


Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/