Re: [CAD_CAM_EDM_DRO] engraving software
Posted by
peter smith
on 2001-09-16 20:57:03 UTC
Elliot
was it Deskengrave from Carl at Deskam.
deskam.com
Peter Smith
was it Deskengrave from Carl at Deskam.
deskam.com
Peter Smith
----- Original Message -----
From: "Elliot Burke" <elliot@...>
To: "CAD_CAM_EDM_DRO" <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Sunday, September 16, 2001 6:20 PM
Subject: [CAD_CAM_EDM_DRO] engraving software
> A few months ago there was a freeware engraving program mentioned here.
> Since then my hard drive crashed, taking with it a weeks work and that
URL.
> As I recall it was a windows program, did engraing in a line or on an arc.
>
> Does anyone have any ideas where it is?
>
> It would be really nice if an engraving program understood that an
engraving
> cutter is a cone. Do they?
>
> Am being more careful about backups now, thanks.
>
> Elliot Burke
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
Discussion Thread
Elliot Burke
2001-09-16 12:07:00 UTC
engraving software
Gail & Bryan Harries
2001-09-16 18:07:21 UTC
RE: [CAD_CAM_EDM_DRO] engraving software
HighTech
2001-09-16 20:41:13 UTC
RE: [CAD_CAM_EDM_DRO] engraving software
peter smith
2001-09-16 20:57:03 UTC
Re: [CAD_CAM_EDM_DRO] engraving software
alenz@c...
2001-09-17 04:13:39 UTC
Re: engraving software
IMService
2001-09-17 07:51:36 UTC
Re: engraving software