Re: CNC Speeds
Posted by
PTENGIN@x...
on 1999-10-08 19:27:32 UTC
In a message dated 10/08/1999 1:00:58 AM Hawaiian Standard Time,
john@... writes:
<< The output from these is fantastic. One job is to cut spanners from 1/8"
steel
sheet very similar to the ones you get with an angle grinder. This cuts them
faster than you could trace round one. They get 600 per sheet and it takes 20
minutes per sheet including loading and unloading.
--
Regards,
John Stevenson at
L Stevenson [Engineers]
Nottingham, England. >>
Dear John,
I'd like three of these lasers. Please send Via UPS blue. Advise on cost.
Peter ;)
john@... writes:
<< The output from these is fantastic. One job is to cut spanners from 1/8"
steel
sheet very similar to the ones you get with an angle grinder. This cuts them
faster than you could trace round one. They get 600 per sheet and it takes 20
minutes per sheet including loading and unloading.
--
Regards,
John Stevenson at
L Stevenson [Engineers]
Nottingham, England. >>
Dear John,
I'd like three of these lasers. Please send Via UPS blue. Advise on cost.
Peter ;)