RE: [CAD_CAM_EDM_DRO] Gecko G3X0 Was: Digitizer Probe

Glad to see you have finally seen the light. I have been preaching Gecko
G3X0 servo drives since I connected the first beta unit to my machine.
Thanks to Mariss for creating such a low cost high performance solution.

Tim
[Denver, CO]

> -----Original Message-----
>
> I thought I should mention this,...... Anyone that is thinking of
> steppers versus servo's, go the servo route! Get Gecko's
> G320's, a set
> of servo's from camtronics or from
> (http://www.aaaim.com/cgi-local/shop991/shop.pl/SID=14213756265/page=D
> CME.htm#DCME9450) part # DCME9950. Same thing ??
> Build a power supply,.. get a 10 amp battery charger from Wal
> Mart for
> the transformer 39.00 ,25 amp rect. from Radio Shack 2.99, 15000 MFD
> Caps 10.00 After all the crap I went though with steppers,..... go
> servo ! Need help,Questions ?? Call me at 850-722-7713 after 6:00 PM
> CT. I feel as a fellow CNCer I would help with what I learned. What's
> a call,..10 cents a minute. E-mail is Ok but I can answer more
> questions over the phone.
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/