Re: [CAD_CAM_EDM_DRO] EMC BDI (Re: Getting started, were to begin ? )
Posted by
Jon Elson
on 2001-09-26 21:55:22 UTC
shawnusa@... wrote:
be able to work with EMC. There are a few fine points, like setup
and hold time on changes of the direction signal relative to the
step pulse. But, in general, all that can be taken care of in the
configuration process.
Jon
>Any stepper driver that accepts step and direction signals should
> What stepper controllers can I build using schmatic/plans that
> support the EMC software. I've been looking and have not found
> and "kits"/schematics, that say out write they support EMC. Any
> suggestions from the EMC pro's. I realy want to build my own, but
> willing to look at any alternatives.
be able to work with EMC. There are a few fine points, like setup
and hold time on changes of the direction signal relative to the
step pulse. But, in general, all that can be taken care of in the
configuration process.
Jon
Discussion Thread
dlantz@a...
2001-09-26 07:03:53 UTC
RE: [CAD_CAM_EDM_DRO] EMC BDI (Re: Getting started, were to begin ? )
shawnusa@e...
2001-09-26 07:30:38 UTC
EMC BDI (Re: Getting started, were to begin ? )
dlantz@a...
2001-09-26 07:33:11 UTC
RE: [CAD_CAM_EDM_DRO] EMC BDI (Re: Getting started, were to begin ? )
shawnusa@e...
2001-09-26 07:44:52 UTC
EMC BDI (Re: Getting started, were to begin ? )
Tim
2001-09-26 09:52:16 UTC
RE: [CAD_CAM_EDM_DRO] EMC BDI (Re: Getting started, were to begin ? )
shawnusa@e...
2001-09-26 11:48:05 UTC
EMC BDI (Re: Getting started, were to begin ? )
Jon Elson
2001-09-26 21:55:22 UTC
Re: [CAD_CAM_EDM_DRO] EMC BDI (Re: Getting started, were to begin ? )
seanc62@y...
2001-09-27 04:54:57 UTC
EMC BDI (Re: Getting started, were to begin ? )