Re: [CAD_CAM_EDM_DRO] Perplexing problem with EMC BDI

Hi John

Jon Elson has already mentioned backlash comp - Take a look at emc.var to see
if 0.007 crops up there. If so, change it to 0.

Regards, Paul.

On Wednesday 03 October 2001 4:08 am, jguenther@... wrote:
> I have the following problem with EMC, the BDI version. The scenario
> is this, system up and running, estop off, machine on, all axis homed
> and set to 0.0000. Enter the command g0 x0 and the X axis will move
> to -0.0077. If you enter the command g0 x1 the X axis will move to
> 0.9923, g0 x2 will get you 1.9923 of movement. Entering the command
> g0 x0 will send the X axis to -0.0077. Go to manual mode, home the
> axis to 0 and repeat the above commands with the same results. It
> also happens if you use g1 instead of g0. This does NOT happen on
> any other axis. Any suggestions would be greatly appreciated.
>
> John Guenther