Re: [CAD_CAM_EDM_DRO] spur (?) gear attached to timing belt pulley - Hopefull...

In a message dated 10/5/2001 9:37:57 PM Pacific Daylight Time,
multi-volti@... writes:

>
> A timing belt in my machine is obsolete, as far as I can tell (7/16"
> pitch and 7/16" width trapezoidal 'teeth').
>

If you are near a KAMAN Bearing House I would suggest that you take the belt
in to them. You might get one a bit wider, and trim it down. sand the cut
edge a bit. Been there done that.
bill


[Non-text portions of this message have been removed]