Re: U-BUILD Machine & Power Tools catalog

Hi Tim,
What that guy did was wrong! But on the other hand you allow
two other people to constantly hawk their product! You can't mention
a new software without one guy chirping in about what his will do.
Guess those guys are persional friends. I have never seen them warned.

Bob

--- In CAD_CAM_EDM_DRO@y..., "Tim Goldstein" <timg@k...> wrote:
> Just to help everyone to know what is considered proper and what is
not on
> this list I wanted to post a response to this particular message.
>
> I have been in communication with the poster and have had a very
friendly
> discussion explaining the nature of this list and pointing out that
this
> particular posting is pushing the limits of what is considered
acceptable.
> While we welcome selling on the list we are against spamming (even
if it is
> for something that may be of interest) and blatant commercial use
of this
> list. We have many commercial vendor on this list and they are some
of the
> most knowledgeable and frequent posters. No complaints with that or
them
> mentioning their products when appropriate.
>
> Here is what I have sent to the poster of this message in my last e-
mail to
> him:
> Guess the best way to put it is, if you want to participate in our
little
> community as an active member sharing your knowledge and mentioning
what you
> have when appropriate we are glad to have you. If you want to just
post
> advertisements and that is all we hear from you then you will not be
> welcome.
>
> Tim
> [Denver, CO]
> All for having another active member. Completely against our
community being
> littered with ads.
>
> > -----Original Message-----
> >
> > Addresses:
> > FAQ: http://www.ktmarketing.com/faq.html
> > FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/