RE: [CAD_CAM_EDM_DRO] Re: TurboCNC and general computer questions
Posted by
HighTech
on 2001-10-16 17:34:38 UTC
Old dos is found on every win 95 and 98 disk. Go to the 98 cd open it
look in tools you will find oldmsdos file.
Derek
Ray
From: "Dale Smith" <mediasmith@...>
<s>
Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
look in tools you will find oldmsdos file.
Derek
Ray
From: "Dale Smith" <mediasmith@...>
<s>
>Get an old DOS 6.22 boot disk somewhere and boot from a floppy. Compare<s>
>the file size on the 6.22 command com and the one on your hard drive. If
> the size and creation date are the same, you should be OK.
Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Discussion Thread
Ray
2001-10-16 06:24:40 UTC
Re: TurboCNC and general computer questions
Carol & Jerry Jankura
2001-10-16 06:35:03 UTC
RE: [CAD_CAM_EDM_DRO] Re: TurboCNC and general computer questions
Randy Gordon-Gilmore
2001-10-16 11:37:47 UTC
DR-DOS, was Re: TurboCNC and general computer questions
HighTech
2001-10-16 17:34:38 UTC
RE: [CAD_CAM_EDM_DRO] Re: TurboCNC and general computer questions