Re: [CAD_CAM_EDM_DRO] he's nearing completion! EMC and 4th axis

Hey Doc

I have noticed the same quirk, in that I could get a higher rate
in one direction than the other. I believe that was when I was
using freqmod. Since I have installed the latest RPM I have
switched back to steppermod (since the lockup problem has
been fixed). Max velocity has gone up since switching to
steppermod. I can do at least 350 IPM rapids using an AMD 450
and Gecko G340's. I could probably do faster than that but
have not tried.

Bill

>
> I am still getting the "following error" at very high step rates

> above ~ 8 revs per second at 400 steps per rev) I originally thought
> it was due to simply being at the max digital output of the port but
> I doubt that now because I can get 10 revs/sec if the axis is going
> in the negative without problem but in the positive direction it will
> error out at ~8 steps/sec.
>
> Thanks again
> Doc Holliday
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>