Stereo Lithography
Posted by
jfisher@s...
on 2001-10-17 12:08:59 UTC
This may be entirely the wrong group and I don't want to upset
anyone, but does any one in this group have any experience with
stereo lithography or rapid prototyping? I know you folks output
to mills and lathes but I havent been able to find enough info out
about SL to make certain descisions about a project I beginning.
The other rapid prototyping group has very little traffic, but this
group is well attended.
Any info or direction would be helpful.
Jack
anyone, but does any one in this group have any experience with
stereo lithography or rapid prototyping? I know you folks output
to mills and lathes but I havent been able to find enough info out
about SL to make certain descisions about a project I beginning.
The other rapid prototyping group has very little traffic, but this
group is well attended.
Any info or direction would be helpful.
Jack
Discussion Thread
jfisher@s...
2001-10-17 12:08:59 UTC
Stereo Lithography
ppump11578@a...
2001-10-17 12:58:51 UTC
Re: [CAD_CAM_EDM_DRO] Stereo Lithography
Gail & Bryan Harries
2001-10-17 13:23:26 UTC
RE: [CAD_CAM_EDM_DRO] Stereo Lithography
cadcamcenter@y...
2001-10-17 13:34:37 UTC
Re: Stereo Lithography
ccs@m...
2001-10-17 13:37:41 UTC
Re: [CAD_CAM_EDM_DRO] Stereo Lithography
Tim
2001-10-17 13:57:33 UTC
RE: [CAD_CAM_EDM_DRO] Re: Stereo Lithography
Fred Smith
2001-10-17 14:15:25 UTC
Re: Stereo Lithography
cadcamcenter@y...
2001-10-17 16:12:26 UTC
Re: Stereo Lithography
Carlos Guillermo
2001-10-17 17:42:42 UTC
RE: [CAD_CAM_EDM_DRO] Stereo Lithography