Re: Servo motor maximum voltage rating

Peter--I appreciate your response. I would normally be running light
loads as this is on a Maxnc benchtop mill but would probably have to
be concerned about what happens in the event of a collision. I may
take that chance seeing that these small servos are relatively cheap
as surplus.
Nelson

--- In CAD_CAM_EDM_DRO@y..., "Peter Seddon" <peter@s...> wrote:
> Higher speed, but under any sort of load possible flash over at the
> brushgear and consequent damage. Motor would definitely not be able
to
> deliver full load at this higher speed.
>
> Regards Peter
>
>
> ----- Original Message -----
> From: <npalen@n...>
> To: <CAD_CAM_EDM_DRO@y...>
> Sent: Friday, October 26, 2001 3:33 AM
> Subject: [CAD_CAM_EDM_DRO] Servo motor maximum voltage rating
>
>
> > Hello--I'm running some small pitman servo motors rated at 30
volts
> > on a 24 volt power supply. What happens if I switch to a 48 volt
> > supply to get better performance? Instant destruction?
> > Thanks.
> > Nelson
> >
> >
> >
> > Addresses:
> > FAQ: http://www.ktmarketing.com/faq.html
> > FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> >
> > Post messages: CAD_CAM_EDM_DRO@y...
> > Subscribe: CAD_CAM_EDM_DRO-subscribe@y...
> > Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@y...
> > List owner: CAD_CAM_EDM_DRO-owner@y..., wanliker@a...
> > Moderator: jmelson@a... timg@k... [Moderator]
> > URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> > bill,
> > List Manager
> >
> >
> >
> > Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
> >
> >
> >
> >