CAD CAM EDM DRO - Yahoo Group Archive

Controller not responding

Posted by bruce@k...
on 2001-10-31 21:14:03 UTC
I have an Anilam M control on a Lagun mill and the Green and Orange
board are bad, check by Anilam. I don't recall what these are for;
one has the scales going to them and the other the pendent. Does
anybody now where I might fine replacements or is anybody on this
list up to tackling the job of repairing these boards? I don't know
specifically what's wrong with them just know these to boards are
bad. Anilam wants $2400.00 to fix them (OUCH).
Just my last ditch effort to save my controller before switching to
EMC
Your help will be greatly appreciated.

Regards,
Bruce Klawiter

Discussion Thread

bruce@k... 2001-10-31 21:14:03 UTC Controller not responding