Re: Stepper source URL ..was:(Re: Brushless Servo)

I bougth a few pof them. They are removed from service. One had a bent shaft
otherwise they are ok. The other problem is that the main drive shaft is
.312 vice .250
Dan
-----Original Message-----
From: drew@... <drew@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Friday, October 15, 1999 3:05 PM
Subject: Re: [CAD_CAM_EDM_DRO]Stepper source URL ..was:(Re: Brushless Servo)

>From: drew@...
>
>Anyone know anything about these motors? Unipolar/bipolar? Torque?
>
>Thanks,
>Drew
>
>On Oct 15, 2:55pm, JVCroad@... wrote:
>> Subject: Re: [CAD_CAM_EDM_DRO]Stepper source URL ..was:(Re: Brushless

Serv

>> From: JVCroad@...
>>
>> There's some nice little NEMA 23 size steppers for only USD 7.95 at:
>>
>> http://www.alltronics.com/stepper_motors.htm
>>
>> 1.7 V 3.4A
>>
>>
>> JC
>>
>> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion

>of shop built systems in the above catagories.
>> To Unsubscribe, read archives, change to or from digest.
>> Go to: http://www.onelist.com/isregistered.cgi
>> Log on, and you will go to Member Center, and you can make changes there.
>> For the FAQ, go to http://www.ktmarketing.com/faq.html
>> bill,
>> List Manager
>>-- End of excerpt from JVCroad@...
>
>
>
>--
>Drew Rogge
>drew@...
>
>>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>For the FAQ, go to http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>