CAD CAM EDM DRO - Yahoo Group Archive

Re: Stepper source URL ..was:(Re: Brushless Servo)

Posted by Dan Mauch
on 1999-10-16 06:11:35 UTC
They would be ok for a sherline. I would say they have about 60 oz in
torque.
Dan
-----Original Message-----
From: stratton@... <stratton@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Friday, October 15, 1999 3:08 PM
Subject: Re: [CAD_CAM_EDM_DRO]Stepper source URL ..was:(Re: Brushless Servo)


>From: stratton@...
>
>> From: drew@...
>>
>> Anyone know anything about these motors? Unipolar/bipolar? Torque?
>>
>
>They look to be rather small...
>
>
>--
>Christopher C. Stratton, stratton@...
>Engineer, Instrument Maker & Horn Player
>(978)538-5179 work, (617)492-3358 home
>30 Griswold Street Cambridge, MA 02138
>http://www.mdc.net/~stratton
>
>>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>For the FAQ, go to http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>

Discussion Thread

JVCroad@x... 1999-10-15 11:55:53 UTC Re: Stepper source URL ..was:(Re: Brushless Servo) drew@x... 1999-10-15 15:02:44 UTC Re: Stepper source URL ..was:(Re: Brushless Servo) stratton@x... 1999-10-15 15:09:27 UTC Re: Stepper source URL ..was:(Re: Brushless Servo) Dan Mauch 1999-10-16 06:10:43 UTC Re: Stepper source URL ..was:(Re: Brushless Servo) Dan Mauch 1999-10-16 06:11:35 UTC Re: Stepper source URL ..was:(Re: Brushless Servo) JVCroad@x... 1999-10-16 08:41:18 UTC Re: Stepper source URL ..was:(Re: Brushless Servo)