Re: getting closer to a running CNC system.....software question

> As of now I have it configured to run TurboCNC on my PC, but after
> looking at Master5, I'm tempted to put my good computer in the

garage

> and run that instead of the DOS based system. Has anyone used both
> systems and if so, is it worth the additional expense for the

Master5

> with respect to the cost of the software and hardware needed?

I would take a hard look at EMC for your controller software. I can't
say enough about it. And it's free !! Well 10 bucks if you get Ray to
burn you a copy. I was so happy with it I sent him 20.

Frank
FRP Enterprise