Re: Stepper drivers at http://www.oatleyelectronics.com/stepper.html

I have ordered from them before, but the kit's that I ordered was the forerunner to the
MOSFET kit. The board quality was good and the kit did what it said would.
The good thing to remember is that the AUS. dollar is about 67 cent's on an USA.
dollar. a problem is that his site isn't secure so you have to call or fax the
to charge something. The boards that I ordered required power resisters
for current limiting.


Mark Ehle wrote:

> From: "Mark Ehle" <mehle@...>
>
> Hello, all -
>
> Does anybody know anything about the stepper driver kits available from
> Oatley Electronics? I'm talking about their MOSFET CNC STEPPER MOTOR
> CONTROLLER KIT on the top of this page:
>
> http://www.oatleyelectronics.com/stepper.html
>
> They look like a good deal - 100V, 14 amp, for only $45. I'm curious if they
> are for unipolar or bipolar, L/R or chopper, do they build easy, etc.
>
> (I am not affiliated with them in any way; this is not a plug for Oatley
> Electronics)
>
> Mark Ehle
>
> Battle Creek, MI
>
> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager