CAD CAM EDM DRO - Yahoo Group Archive

RE: Stepper drivers at http://www.oatleyelectronics.com/stepper.html

Posted by Tim Goldstein
on 1999-10-17 12:00:39 UTC
> -----Original Message-----
> From: batwings@...
--SNIP--
> Looks like these are nothing but the controller cards. You can buy
> controller cards from a number of sources at similar prices, such as
> Applied Motion in Watsonville CA. They have features like
> dip-switch output
> level, winding enable or off, auto-current reduction if not used
> in certain
> time span, and are also half-step (.9 deg/step with 200 steps/rev motor).

Do you have a URL for them??

> Software makes a big diff in the success of these projects. My suggestion
> would be to consider that part first.

It sure does. I tried a couple and the best I have found is EMC. It supports
more of the g-codes than most and runs my stepper setup smoother than
anything else I have used.

Tim
[Denver, CO]

Discussion Thread

Mark Ehle 1999-10-17 08:21:58 UTC Stepper drivers at http://www.oatleyelectronics.com/stepper.html Dan Mauch 1999-10-17 09:17:26 UTC Re: Stepper drivers at http://www.oatleyelectronics.com/stepper.html Tim Goldstein 1999-10-17 09:32:11 UTC RE: Stepper drivers at http://www.oatleyelectronics.com/stepper.html batwings@x... 1999-10-17 00:16:42 UTC Re: Stepper drivers at http://www.oatleyelectronics.com/stepper.html Tim Goldstein 1999-10-17 12:00:39 UTC RE: Stepper drivers at http://www.oatleyelectronics.com/stepper.html batwings@x... 1999-10-17 03:30:15 UTC RE: Stepper drivers at http://www.oatleyelectronics.com/stepper.html jimmy staton 1999-10-17 13:38:41 UTC Re: Stepper drivers at http://www.oatleyelectronics.com/stepper.html Carlos Guillermo 1999-10-17 14:44:11 UTC RE: Stepper drivers at http://www.oatleyelectronics.com/stepper.html batwings@x... 1999-10-17 05:58:23 UTC RE: Stepper drivers at http://www.oatleyelectronics.com/stepper.html Peter Bailey 1999-10-17 16:25:18 UTC Re: Stepper drivers at http://www.oatleyelectronics.com/stepper.html