RE: [CAD_CAM_EDM_DRO] Re: RS274 vs RS274-NIST

Hi, Alan.

It's got to be something temporary, because I just vectored there using the
link below. The manual is a "good looking" set of HTML links and could very
well be something that the Linux site points to. Personally, I'd have
preferred that they would have left it in PDF format. I wound up putting it
through Word to reformat and clean it up before I printed it.

-- Jerry.

|-----Original Message-----
|From: Alan Marconett KM6VV [mailto:KM6VV@...]
|Sent: Saturday, November 24, 2001 2:10 PM
|To: CAD_CAM_EDM_DRO@yahoogroups.com
|Subject: [CAD_CAM_EDM_DRO] Re: RS274 vs RS274-NIST
|
|
|Hi Jerry,
|
|That first link is not working for me. In fact, the linuxcnc.org's 274
|link also appears to be broken. I think it is the same one I downloaded
|some time before. The second link is interesting, good write-ups for
|the "standard" Gcode set.
|
|Yeah! I'm having fun!
|
|Alan KM6VV
|May the SWARF be with you!
|
|
|Carol & Jerry Jankura wrote:
|>
|> Alan:
|>
|> I found my release 3 publication on the web at:
|>
|> http://www.linuxcnc.org/handbook/RS274NGC_3/RS274NGC_3TOC.html
|>
|> but it doesn't have any mention of the G7x codes.