CAD CAM EDM DRO - Yahoo Group Archive

Re: burny-2.5

Posted by andy@o...
on 2001-11-26 11:09:38 UTC
Dave - I replaced our optical tracker oxy / gas cutting system with a
Camtronics / Gecko 340s / EMC system. I pretty much ingnored the
existings electronics and replaced the servo motors with new ones
with encoders. Mine has a 39:1 gearbox and rack and pinion drive so
the motor size was not too important.

I understand that electrical interference is more of a problem with a
plasma cutters.

I don't have EMC turning the cutting gas on yet, but it is possible
to rig up a relay to turn on your arc.

My entire cost was about $1300 not including my time. How much did
they want for the Burny 2.5?

Andy

Discussion Thread

dlantz@a... 2001-11-26 10:09:55 UTC burny-2.5 andy@o... 2001-11-26 11:09:38 UTC Re: burny-2.5 dlantz@a... 2001-11-26 11:13:54 UTC RE: [CAD_CAM_EDM_DRO] Re: burny-2.5