Re: Parallel Port data

Hi Jon,

Any software that outputs to the parallel port, CNCPro, TurboCNC,
mastercam etc.
I believe that the lister was somehow multiplexing one data line and
sending pre-configured codes (pobably m codes with an identifier).

Thank you
Tom

--- In CAD_CAM_EDM_DRO@y..., Jon Elson <elson@p...> wrote:
> tcsibor@v... wrote:
>
> > I seem to recall reading a post a while ago about being able to
> > control extra data (relays etc.) through the parallel port from G
or
> > M codes.
> >
> > If anyone has that information, I would sure appreciate it.
>
> Using what software? Without that, we can't be of much help.
>
> Jon