RE: [CAD_CAM_EDM_DRO] Parallel Port data

Tom:

This will depend on the particular G-Code interpreter that you are using.
I'm using TurboCNC, which supports items such as coolant and spindle power
and direction. You'll have to check on your software's specifications....

-- Carol & Jerry Jankura
Strongsville, Ohio
So many toys, so little time....


|-----Original Message-----
|From: tcsibor@... [mailto:tcsibor@...]
|Sent: Tuesday, November 27, 2001 10:24 AM
|To: CAD_CAM_EDM_DRO@yahoogroups.com
|Subject: [CAD_CAM_EDM_DRO] Parallel Port data
|
|
|I seem to recall reading a post a while ago about being able to
|control extra data (relays etc.) through the parallel port from G or
|M codes.
|
|If anyone has that information, I would sure appreciate it.
|
|Thank you
|Tom Csibor
|
|
|Addresses:
|FAQ: http://www.ktmarketing.com/faq.html
|FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
|
|Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
|Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
|Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
|List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
|Moderator: jmelson@... timg@... [Moderator]
|URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
|bill,
|List Manager
|
|
|
|Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
|
|
|