Re: [CAD_CAM_EDM_DRO] Cheap Power Supply

Hi, if the power supply goes into shutdown then a 10 ohm 10 watt wire wound
resistor across the 5 volt circuit should be enough load to start and run.
cul brian f.

----- Original Message -----
From: "Krahabors" <krahabors@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, November 28, 2001 5:10 AM
Subject: Re: [CAD_CAM_EDM_DRO] Cheap Power Supply


> >
> > I do, however, have a question which SKS may be able to answer. I read
> > somewhere that these PSUs don't like being run off-load - as one might
do
> > before the system is complete. Any experience out there?
> >
>
>
> Computer power sources can be different, some of them will run with no
load,
> others will not. It depends on design.
> If the PS requires some kind of load, the load usually must be connected
to +5V
> output, others can be left free.
>
> KPL
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>